37
Error
Description & Possible Solution
F1 01 Initialization error. No master power board found.
• Check model ID is set correctly for the model you are working on, refer page 33.
• Check harness connections to master power board.
• Replace master power board.
02
Initialization error. No slave power board found.
• Check model ID is set correctly for the model you are working on, refer page 33.
• Check the harness connections at the slave power board.
• Replace the slave power board.
03
General software error.
• Try powering the oven off and on. If the problem persists, replace the Clock Board.
04
Communication error. The master power board does not respond in time or at all.
• Check connection to master power board.
• If the problem persists, replace Power Board.
05
Communication error. The slave power board does not respond in time or at all.
• Check connection to slave power board.
• If the problem persists, replace the slave power board.
06
Unknown model ID. The clock board does not support the model ID set on the power
board.
• Turn product off and back on at the wall, check the model ID via tecnician mode, refer
p32.
• If the problem persists, replace clock module and set the correct model ID, refer p33.
16
18
Crystal Oscillator fault. This can occur during baking with a lot of condensation.
• Let the oven cool down and dry out. Then power the oven off and on.
• If the problem persists, replace the Clock Board.
10
11
12
13
14
15
17
19
20
21
Critical software/hardware fault.
• Try powering the oven off and on. If the problem persists, replace the clock board.
7.2 Failure Alerts
Clock Board Faults
To Next Page
Loading...
