Fisher & Paykel OB76DD - Page 49

48
1. Remove the door from the oven.
2. Lay the door face down on a flat, clean
working surface.
3. Remove the four hinge screws on the bottom
of the door and the eight retaining screws
down the sides of the door.
4. Separate the inner and outer door assemblies.
5. Remove the six screws holding the inner glass
door assembly. 3 on each side.
6. Drill out the 4 rivets holding the stanchion to
the door.
7. Lift the stanchion out and remove the hinge by
removing the two screws.
8. Reassemble in reverse order.
NOTE:
• You will need to rivet the stanchions back onto
the door with 2 x 3mm rivets.
• Make sure the inner door sits inside the bottom
of the outer door at the bottom.
• Make sure the gasket is sitting in the correct
position at the sides when you put the inner
door back on.
• Make sure the top of the inner door slots into
the trim at the top.
To separate the inner and outer door &
remove the hinge