Microwave oven
Installation instructions
OM25BLCX1 model
NZ AU
Important!
SAVE THESE INSTRUCTIONS
The model shown in this document may not be available in all markets and is subject to change at any time. For current details about model and specification availability in your country, please go to our local website
listed at the end of this document or contact your local Fisher & Paykel dealer.
4
CABINETRY DIMENSIONS
D D
B
C
C
A
E
E
Installation diagrams for illustration purposes only
Cabinetry dimensions (mm) OM25BLCX1 model
A width
600
B inside width
560 +8
C depth
550
D height
450 +2
E air vent
45
Cut out dimensions above are to be used as minimum dimensions.
3
PRODUCT DIMENSIONS
A
B
C
Installation diagrams for illustration purposes only
Product dimensions (mm) OM25BLCX1 model
A microwave height
460
B microwave width
595
C microwave depth
470
1
SAFETY AND WARNINGS
WARNING!
Electric Shock Hazard
Read and follow the IMPORTANT SAFETY INSTRUCTIONS outlined in this
Installation instructions before installing or operating this appliance.
Failure to do so can result in death, electric shock, fire or injury to persons.
Important safety instructions
The oven is fitted with a plug and must be only connected to a properly installed earthed socket. In
accordance with the appropriate regulations, the socket must only be installed and the connecting
cable must only be replaced by a qualified electrician.
If the plug is no longer accessible following installation, an all-pole isolating switch must be present on
the installation side with a contact gap at least 3mm.
This microwave oven must be placed on a flat, stable surface to hold its weight and the heaviest food
likely to be cooked in the oven.
2
GETTING STARTED
Tools required (not included)
No. 2 drill bit – long
Electric drill
Phillips head screwdriver
Parts supplied
Screw type A (x 2) Bracket (x 1) Screw type B (x 1) Plastic cover (x 1)
Do not place the oven where heat, moisture, or high humidity are generated, or near combustible
materials.
Do not operate the oven without glass tray, roller support and shaft in their proper positions.
Make sure that the power supply cord is undamaged and does not run under the oven or over any hot
or sharp surface.
Do not use the oven outdoors.
If the supply cord is damaged, it must be replaced by a Fisher & Paykel authorised technician in order
to avoid hazard.
Before you install the microwave, please ensure that
All the packing materials are removed from the inside of the door.
WARNING: Check the oven for any damage, such as misaligned or bent door, damaged door seals
and sealing surface, broken or loose door hinges, latches and dents inside the cavity or on the door.
Ifthere is any damage, do not operate the oven and contact a Fisher & Paykel authorised technician.
The socket must be readily accessible after installation so that it can be easily unplugged in
anemergency.
The built-in cabinet shall not have a rear wall behind the appliance.
Minimum installation height is 85cm.
Do not cover ventilation slots and air intake points.
5
THE BOTTOM CABINET TEMPLATE
Read the instruction on the
BOTTOM CABINET TEMPLATE.
Put the template on the
cabinet’s bottom panel.
To Next Page
Need help?
General
