Fitting the anti-tilt bracket
Important!
To restrain the appliance and prevent it tipping accidentally, the anti-tilt bracket supplied must be fitted
according to the instructions below.
1
Drill four 8mm diameter holes for the fixing screws (two in the wall and two in the floor-see
Fig.3) and insert the plastic plugs supplied.
Important!
Before drilling the holes, check that you will not damage any pipes or electrical wires.
2
Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in
Fig. 3.
3
After attaching the anti-tilt bracket securely, slide the cooker into place. Ensure that the left rear
foot slides under the bracket, as shown in Fig.3.
4
Replace the kickstrip using the two screws.
Important!
When sliding the cooker into place be careful not to trap the power supply cable in the anti-tip bracket. Pay
extra attention to the gas connection hose.
Beware of sharp edges when removing or replacing the drawer.
Fig. 3 Attaching the
anti-tilt bracket and
sliding the cooker
into place
To Next Page
Loading...
