19
Installation instructions
To connect the gas supply:
1
Fit the 1/2” BSP (female) connector (supplied with the cooker in a separate kit) to the gas
inlet at the rear of the cooker interposing the gasket. Check the correct positioning of the
connector as shown and always use two suitable spanners (Fig 8c).
2
Connect the gas supply to the gas inlet at the rear of the cooker. The pipe is not to cross
the cooker.
3
To avoid damage to the appliance gas rail inlet pipe tighten
the fittings using two suitable spanners (Fig. 8c).
4
Using a suitable leak detection fluid solution (e.g. Rocol)
check each gas connection one at a time by brushing the
solution over the connection. The presence of bubbles will
indicate a leak. If there is a leak, tighten the fitting and
then recheck for leaks.
IMPORTANT!
Do not use a naked flame to test for leaks.
It is the responsibility of the gas installer to ensure that the
product is fully tested and commissioned in accordance with
current regulations and to ensure there are no gas leaks.
Gas
inlet pipe
Fig. 8b Gas
supply inlet
Fig. 8c Connecting the gas
1/2” BSP (female)
1/2” G cylindrical
(ISO 228-1) male
1/2” G cylindrical
(ISO 228-1) female
20 mm
10 mm
20 mm
10 mm
Cooker manifold
Manifold male
pipe fitting
Gasket (
*
)
Connector (
*
)
(
*
) Supplied with the appliance in a separate kit.
To Next Page
Loading...
