28
First use
Remove the side racks to fit the Catalytic panels (if not already fitted)
1
Remove all shelves and trays.
2
For easier access to the fixing screws, you may remove the oven door first. See ‘Removing and
refitting the oven door’ in Care and Cleaning.
3
Remove the side racks on both sides:
4
Using a small coin or a flat-head screwdriver, loosen and remove both fixing screws.
5
Gently remove the side rack.
Fitting the Catalytic panels
6
Fit the catalytic panel. When fitting the catalytic panel make sure that
- the arrows are pointing upwards
-the panel with the hole in it is on the right oven wall.
Refitting the side racks
7
To refit the side racks
- make sure that they are the right way up, as in the illustrations, and that you
tighten the fixing screws.
8
If not already fitted, fit the telescopic sliding shelf supports. See “Care and cleaning’ for
instructions.
Fig. 18 Refitting the side racks
To Next Page
Loading...
