46
A
B
S
T
Care and cleaning
Replacing the triple-ring wok and dual burners
Carefully replace the burner parts as per the following Figs.
Fit the flame spreader to the housing as shown by the arrow in the Figs.30a-30b. Make sure the
burner is not able to rotate (Fig. 31).
Check that:
the ignitor is always clean to ensure trouble-free sparking.
the probe is always clean to ensure correct operation of the safety valves (some models only).
Note: both the ignitor and probe must be very carefully cleaned using a toothbrush and
methylated spirits (see Fig.24).
Fig. 30a Correct positioning of
flame spreader - triple-ring wok burner
Fig. 30b Correct positioning of
flame spreader - dual burner
Fig. 31 Correct positioning of
cap and ring - triple-ring wok and dual burner
Probe
Ignitor
Ignitor
Probe
Fig. 32 Incorrect and correct positioning
of cap and ring - triple-ring wok and dual burner
Ring
Cap
To Next Page
Loading...
