Fig. 11 Assembling the backguard
Connecting the power supply cable
This cooker must be connected to the electricity supply only by an authorised person.
To connect the power supply cable to the cooker, it is necessary to:
1. Unhook the terminal board cover by inserting a screwdriver into the two hooks ‘A’ (fig. 12).
2. Unscrew the screw ‘D’ and open completely the cable clamp ‘E’ (figs. 14).
3. Position the U bolts ‘F’ onto terminal board ‘G’ (figs. 14) according to the diagrams in fig. 13.
4. Connect the phase, neutral and earth wires to terminal board ‘G’ according to the diagrams in figs. 13 - 14.
5. Strain the feeder cable and block it with cable clamp ‘E’ (by screwing screw ‘D’).
6. Close the terminal block cover (check the two hooks ‘A’ are correctly hooked).
https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Induction/OR90SDBSIX2/User_Guide_OR90SDBSIX2/02_Installation_instructions
Updated: Fri, 08 Mar 2019 10:03:53 GMT
Powered by
9
To Next Page
Loading...
