15
Wash options
Soak
WashSmart™ model only
Use the SOAK option to soak clothes at the end of the wash
phase or when you wish to re-use the wash water.
When you select SOAK your washer will soak for a period of
2 hours before completing RINSE and SPIN. During SOAK your
washer will agitate for a few seconds every minute.
Note: when both the SOAK and QUICK WASH options are
selected, the soak time will be halved.
Nappy sanitisers/bleach
Nappy sanitisers and bleach are very corrosive to metal
surfaces. These should not be used in your machine.
Important!
DO NOT use your washer to soak items in bleach or sanitiser, and if you’ve soaked items in a bucket,
do not tip the contents of the bucket into your machine. The chemicals in these products can
damage your washer. Rinse and wring items out thoroughly before placing them in your machine.
Spin Hold
WashSmart™ & QuickSmart™ model
Use the SPIN HOLD option to:
Remove drip dry garments from a mixed load before the wash
goes into SPIN.
Minimise the clothes creasing when they are left to sit in the
bottom of the bowl at the end of the cycle.
When you have selected SPIN HOLD, the washer will pause at
the end of RINSE, beep and the SPIN light will flash to tell you
that it is waiting for another instruction.
Press START/PAUSE to begin the spin.
Delay Start
WashSmart™ model only
DELAY START will delay the start of the wash cycle for 1, 3 or
9 hours.
Press DELAY START once for a delay of 1 hour. Press again for
3 hours, a third time for 9 hours (and again to return to normal).
Once you press DELAY START your washer will begin the delay
period. You do not have to press START/PAUSE.
Be careful if using DELAY START for non-colourfast clothes as
dyes may run if the clothes are damp.
Your washer will not beep at the end of the cycle if DELAY
START is selected.
Fig.18 Selecting the SPIN HOLD
option
Note: while WashSmart™ model is
shown, setting of the QuickSmart™
model is identical
WashSmart™
Fig.17 Selecting the SOAK option
Fig.19 Selecting DELAY START
To Next Page
Loading...
