Fisher & Paykel QuickSmart - Solving operating problems; Your washing comes out very wet at the end of the cycle; Vibrating

34
CHANGING PRE-SET OPTIONS
Option Adjustment mode
After using your washer a number of times you may want to fine tune some of the
options to suit your wash needs.
There are a number of pre-set options, which can be altered:
1
The wash temperatures, including changing the ‘Cold’ wash temperature to
‘ControlledCold’.
2
The out of balance recovery routine.
3
The number of beeps at the end of the cycle.
4
Resetting to factory default settings.
To enter Option Adjustment mode
1
Turn your washer on at the wall but do not touch ‘POWER’ .
2
Touch and hold the and buttons together for 3seconds.
You will hear 3quick beeps indicating you have entered
Option Adjustment mode. The washer will show the default
setting for the ‘Cold’ wash temperature.

The diagram on page 35 shows how the wash cycle
iconsrelate to the options you can change.

The ‘Changing pre-set options’ section explains the
different options in more detail.
3
Use buttons on the panel to make your changes to the
pre-setoptions.
4
Touch ‘POWER’ to return to normal mode. Your washer
willautomatically remember your changes.
To change or reset any of the options, repeat the abovesteps.
Entering Option
Adjustment mode