321037
53
11.4.11 Refitting of the FC Drawer
1. There are two locating tabs on the drawer that are required to be fitted first. (Refer to photo
11.4.11)
STEP 1
Step 2
Photo
11.4.11
2. Align the rear locating tab into the slot as shown in step 1.
3. Align the front locating tab into the slot as shown in step 2.
4. Fit the anti-racking bar into the wracking pinion gear ready to fit to the drawer.
5. Both anti-racking pinion gears need to be fitted simultaneously. (If this is not achieved,
damage to the gearing may occur or the drawer will not close correctly.) Refer to photo
12.4.10.1.
Photo
11.4.11.1 Photo 11.4.11.2
6. Place the anti-racking pinion on an angle and slide both pinion gears into position on the slide.
7. Fit the locking tab into position as shown in photo 12.4.10.2.
To Next Page
Loading...
