Fisher & Paykel RF201A - Removing Water Tank; Refitting Water Tank

819091D
54
12.4.8 Removing Water Tank
• Turn the water off at source.
• Remove all shelves.
• Remove the PC duct cover and PC Sensor from duct cover
• Unclip the water reservoir cover from the cabinet liner.
• The reservoir is removed by sliding a flat bladed plastic putty knife or spatula on top of the tank, and
with a folding motion of the spatula, lever the tank lip from the LH side to the RH side until clip is lifted
from liner and the tank is removed.
Diagram A – tank in position
Diagram B Fit spatula on the
RH side of lip and move to RH
side until unclipped.
Diagram A Diagram B
• Remove water tubes from tank.
Hoses are accessible once tank is removed.
12.4.9 Refitting Water Tank
• Place the bottom section of the tank onto protrusion on PC liner (Refer Diagram C and D)
Diagram C Diagram D
• Push the tank towards the rear of the liner until top lip is clipped into position.
• Refit cover (as per Diagram E).