19
HINGE SWAP (OPTIONAL)
Carefully remove hinges from door and
set aside.
Remove top cover and set aside.
Open the door and remove the door
shelves. Loosen the hinge screws
using the supplied Torx T25 driver.
Slide the door out and place onto a
protected surface.
Push on the edge of the outside plates,
lift out and swap to the other side.
1
2
3
4
Use a flathead screwdriver to remove
the inside plates. Move to the other
side ensuring the rounded corners face
the inside.
Swap hinges as illustrated. Ensure
base of hinge is parallel and
tightened securely.
Refit top cover.
Check plates are positioned correctly.
5
6
7
Slot the door back onto the screws
and tighten using a torx key to tightly
secure. Refit the door shelves.
8
Install kit D
Swap alcove bracket with the hinge
bracket. Secure using 3 screws at the
top of the cabinet.
To Next Page
Loading...
