Fisher & Paykel RS36A80J - Attach Side Trim Brackets

16
~
69” (1753mm)
~
40” (1016mm)
~
10” (254mm)
8 ATTACH SIDE TRIM BRACKETS
IMPORTANT!
Before installing your appliance, ensure the dimensions of the finished enclosure are correct for your appliance following the ‘Product and cavity dimensions’ sections.
4 Fix side trim brackets to the side of one
enclosure with screws x2 (#8 x 16 mush
washer). Ensure screws hold tight.
Repeat for remaining side trim brackets.
A
Frameless cabinetry installation
(opened cabinetry doors)
1 Ensure surrounding cabinetry doors are open
before marking screw locations for side trim
brackets (refer to A).
2 On one side of the finished enclosure, starting
from the top, place side trim bracket with the
datum lip overhanging the edge.
Mark screw locations for each side trim
bracket – top, center and bottom (refer to B)
to drill Ø ” x ½” (Ø 2mm x 13mm) deep holes.
Repeat on the opposite side.
3 Break off the datum lip to each side trim
bracket and discard.
Repeat for all side trim brackets.
B
Discard