23
It is important that all four corners of the appliance is supported firmly onto the floor to eliminate any movement.
Installing the appliance on a soft, uneven, or not level floor may result in twisting of the product and poor door sealing.
Raise the appliance using an ⁄” (11mm) hex socket or ⁄” (4mm) hex Allen key. One turn of height adjusting nuts is equivalent to ⁄” (1mm) height travel.
Note: maximum travel is ⁄” (20mm).
1 Level the appliance back to front until all tabs located on the installation aiders are in
contact with adjacent cabinetry. Turn clockwise to raise rollers or counter-clockwise to
lower roller.
Repeat this process on the opposite side.
2 Gently push the front of the appliance to check the stability, and ensure side gaps are
even with enclosure.
Front roller adjustment
Rear roller adjustment
!2 LEVEL YOUR PRODUCT
To Next Page
Loading...
