28
!7 HANGING NON-WATER DISPENSING DOOR PANELS
2 All door panels have full axis adjustment
to ensure they are flush with adjacent
walls, or until satisfactory. To adjust
the height of each panel turn clockwise
to raise stud or counter-clockwise to
lower stud.
3 Once satisfied with all door
panels, secure M8 studs with M8
washer and M8 nut. The top of the
stud must remain below the top
face of the door panel.
4 Secure side bracket forks by tightening
side screws.
Repeat this process for all door panels.
Ensure all door panels are flush with
adjacent walls, adjust accordingly or
until satisfactory.
1 Hang all door panels onto M8 studs and
align the side bracket forks onto the
refrigerator door.
Ensure the forks are positioned around
the body of the side screws (M5 x 10
pan head Phillips screw).
To Next Page
Loading...
