Fisher & Paykel RS80A1 - Custom Door Panel Installation Dimensions - RS80 (Drawer Panel)

Dimensions apply for the preparation and installation of custom door panels.
For Dwg and Dxf files of the below panel preparation download the folder on thekitchentools.fisherpaykel.com.
Recommended hole locations for installing Fisher & Paykel design handle.
Ø 2mm REF
10x Pilot holes recommended
forbracket attachment.
(Do not penetrate front surface).
335mm
111.5mm
29.1mm
87.2mm
492mm
542mm
366mm
All measurements to be made
from top and centerline.
DRAWER PANEL — REAR VIEW
Cut outs are located in attachment bracket for Fisher & Paykel handles only.
Iflocating custom handle in the shaded area above, ensure handle screw heads
are counter sunk into back of panel to avoid interference with hanging bracket.
CUSTOM DOOR PANEL INSTALLATION DIMENSIONS — RS80
598mm
72.7mm
30.3mm
98.5mm
DRAWER PANEL — REAR VIEW
Ø 6mm REF
4x Through holes
recommended for
handle attachment.
12