Fisher & Paykel RS80A1 - Water and Power Supply Connection

Water fittings are not supplied and must be purchased separately. The appliance comes with a pre-connected plastic water tubing.
Ensure there is enough tubing for the water connection and to pull theappliance outforservice, if required.
Move the appliance in front of the cabinetry close enough that you still have access behind for power and waterconnections.
Water fittings kit
(Ice and Water
modelsonly)
Water tap adaptor
(1x)
Collet locking clip
(1x)
WATER AND POWER SUPPLY CONNECTION
1
2
3
Connect the water tap adaptor to a water tap.
Flush water through the hose prior to connection to
the appliance toremove any debris in the hose.
Connect the free end of the plastic tubing fully into a
water tap adaptor. Pull gently to ensure it is locked in.
Secure the connection with a locking key inserted
between the water tap adaptor and locking collet.
Connect to water supply (Ice and Water models only)
22