- 28 -
Fault Code 4 Invalid Option Link Read.
The motor control module heat source option link read is invalid.
Remedy: Replace the motor control module. (Refer to Section 6.35)
Fault Code 6 Door Jammed - User Warning.
The door is unable to close due to either clothes catching or an excessive closing
load.
Remedy: (1) Remove the obstruction.
(2) Reposition or remove some of the load.
(3) Fix the cause of binding in the door closing mechanism.
(4) Replace the motor.
Fault Code 7 Motor Current Excessive.
Remedy: (1) Free up the dryer. Remove overload or cause of jamming.
(2) Replace the motor control module. (Refer to Section 6.35)
(3) Replace the motor. (Refer to Section 6.32)
To Next Page
Loading...
