- 46 -
6.11 Removal of Door Bracket
(a) Follow general servicing instructions for components within the cabinet. (Refer to
Section 6.6)
(b) If the drum door is closed, push down on the tabs
on each side of the drum and slide the drum door
partially open.
(c) Remove the centre clip by squeezing the tabs
together and pushing downwards.
(d) Lift the loop of the hinge springs,
slide the springs out of the door
brackets and remove the clips.
(e) Remove the hinge arms and locking
bar.
(f) Slide the door bracket away from the
door. Slide one side forwards and
the other backwards to disengage it
from the tracks in the drum bridge.
Reassembly
(a) Refit in reverse manner.
When refitting the hinge springs, ensure that they are not reversed or they will not sit
flat. Locate the longer (right hand) leg into the door bracket clips first, then the left
hand leg. Push home.
6.12 Removal of Drum Door
(a) Follow instructions for removal of the door bracket. (Refer to Section 6.11)
(b) Slide the door out of the tracks and lift clear.
Reassembly
(a) Refit in reverse manner.
Lift Spring
Door Bracket
Hinge Arm
Locking Bar
To Next Page
Loading...
