1
2
3-Wi'e "e°
For use where Rocancodes permit grounding through the Neutran wire.
Useapproved 3 wire Power S_ppiy Cord or a 3 wire Cabie for i)ire<t Wiring as described on page 24
Remove ti_e terminal block cover piate
insert the power cord wiri3 a UL listed sraW}reiief li_rougi_ the i_o!eprovided in ti_e cabW}etnear
the terminai bio(k_ Do not tigi_ten strain reiief screw untii wiring connection are compiete
No't÷; a strain reiief must be ued
3 [oosen or remove ti3ecenter terminai biock screw Cor/nect ti3e neulral wire (center) of the p_3wer
uppiy cord Io ti3ecenter terminai screw of li3e lermir/ai bio(k_]ighler/screw
4 Connect ti_e oti_er wires to the upper and lower terminal block crew marked with the
ietter i lighten crew
5 Refit terminal biock cover by inserting *ie * . .
,,_ ,wotab firtonti_erearDaneiofthedrver Secure
cov_wwiti] securing screw_
6 ]igi_ten strain relief screws.
2d
To Next Page
Loading...
