4-Wi " °
Useapproved 4,_wirePower SuppDyCord or a 4-wire CaMe for Direct Wiring as described on page 25,
1 Remove the Iermi!/ai block cover piate
2 inert ti_e power suppiy cabie witi_ a U[ iisted strain reiief ti/rouclh tile i_o!eprovided i!/the cabinet
near the terminai biock Do not tighten strain reiief crew untii wiring co!}nection are compiete
Note: a strain relief must be ued.
s Remove center terminai biock screw_
4 Remove appiiance ground iink by removi!/g ti_e ground connector screw (green screw)
4
'o ;li1:_ :fi:);)l (; //>a(l<(> 1
/sI;:_l;d; )/ tie (o/ (/I k )_-f t:<:
J
_ (:,ve li_<
5 Cor_nectqroHnd wire (green) of tile power suppiy cord to tile ground conducsor green screw
Tigi_ten screw
6 Connect ti_e neutrai wire (wi_ite)of the power suppiy cord to the center terminai crew of ti_e
terminai biock Tkihten screw.
7 Connect ti_e red wire and black wire to the upper and iower terminai biock crew marked with the
better i Tklhten screws.
_7
s Refit terminai biock cover by inserting _ie _ .,,_ ,wo tab first on ti_e rear panei of the dryer and ecure
cover with securing screw_
9 ]ighten Strain Relief screws
$
28
To Next Page
Loading...
