Fisher & Paykel WD8560F1 Installation Leaflet

INSTALLATION LEAFLET
NZ AU GB
Front Loading Washer Dryer
WD8560F1, WD7560P1 and WD8060P1 models
IMPORTANT!
INSTALL APPLIANCE CORRECTLY
The washer dryer must be properly installed and located in accordance with this installation leaflet before it is used. Refer to the
user guide for full details.
UNPACKING
1
Remove the packaging, polystyrene packer and lift the appliance off the base.
2
Remove the hose and accessories.
IMPORTANT!
The cold water should not exceed 35°C.

Inlet water pressure: Maximum 1MPa(150psi), Minimum 100Pa(14.5psi).

Inlet water flow rate: Minimum 6litres/minute.
CONNECTING TO THE WATER SUPPLY
REMOVING TRANSIT SAFETY BOLTS
This washer dryer is fitted with transit safety bolts at the rear to avoid possible damage to the interior during transportation.
IMPORTANT!
The transit bolts MUST be removed prior to operating the washer dryer. Failure to remove these will result in damage to the appliance.
To remove the bolts
1
Use a spanner or socket to unscrew and remove all four
transit bolts at the back of the appliance (A).
2
Pull the black rubber grommets to remove the bolt,
grommet and white plastic spacers from the appliance.
Retain these for future use.
3
Cover the bolt holes with white plastic plugs (B). Push to
clipintoplace.
Removing the transit safety bolts
A
B
LEVELLING YOUR MACHINE
1
Before moving the washer dryer into its final position, check that it is level — front to back and
side to side.
2
Manoeuvre the appliance into its final position (we suggest a minimum clearance of 20mm
eachside)
3
Use a spirit level to check that the washer dryer is correctly level. If needed, pull the appliance
out. Loosen the lock nut using the spanner provided and wind the feet up or down to correctly
level the washer dryer.
4
Using the spanner provided tighten the lock nuts against the base of the appliance to lock
thefeet in position.
continued >
Straight
(tap) end
Elbow
(machine) end
1
Connect the straight end of the inlet hose to the tap and the elbow end to the
washer dryer’s inlet valve. Tighten the inlet hose end by hand until the hose seal
makes contact with the tap sealing face and then tighten a further half-turn.
Make sure there are no kinks in the hose.
2
Turn the tap on and check for leaks. Check for leaks again after 24hours.
INLET HOSE

Fisher & Paykel WD8560F1 Specifications

General

Brand	Fisher & Paykel
Model	WD8560F1
Category	Washer/Dryer
Language	English