Fisher & Paykel WH8060P1 - DIAGNOSTICS LEVELS

479646
57
14 DIAGNOSTICS LEVELS
Diagnostics allows various information to be extracted from the machine while in diagnostics, which can be
used in both static, machine idle and dynamic machine running modes. There are a total of 15 different
levels associated with the washer that are listed in the accompanying table.
While in diagnostics, use the Delay Start + MORE & - LESS buttons to select the diagnostic level required.
E.g. If diagnostic level d09 (Bowl speed RPM) is selected, after 1 second the information that corresponds to
level d09 is displayed in the 7segment display.
1 second later shows 250 RPM
Level
Diagnostic info Displayed
Level
Diagnostic info Displayed
d 00
Last User Warning
d 08
Cycle count
d 01
Last User warning cycle count
d 09
Bowl speed
d 02
Last User warning cycle position
d 10
Target Speed
d 03
Fault Code
d 11
Water level
d 04
Fault code cycle count
d 12
Target Fill level
d 05
Fault cycle position
d 13
Display SW Version
d 06
Current Temperature
d 14
M/C SW Version
d 07
Target Temperature
d 15
Drum Clean cycle count
d 00: Last User Warning
The last user warning is displayed in the LED display.
d 01: Last User Warning Cycle Count
The cycle count at which the last user warning occurred, displayed as 1,000s, 100’s, 10’s & 1’s.
E.g. For a cycle count of 1010 cycles
d 02: Last User Warning Wash Cycle Position
The wash cycle position of the last user warning
Output Displayed on
Screen
Cycle Position
01
Agitation
02
Rinse
03
Spin
d 09
2 5 0
1 0 1 0