44
FAULT CODES
When a continuous series of beeps is sounded, all the lights turn off on the control panel
and a number appears on the display, a fault has occurred. The washer will automatically
enter this mode if a fault occurs. The fault code will be displayed as followed by
a number on the digital display. To stop the sound, press any button and perform the
following steps:
1 Turn your washer off at the power point.
2 Wait oneminute and turn it back on.
3 Check your washer is correctly levelled.
4 Remove your wash load.
5 Perform a
RINSE cycle.
6 If the fault re-occurs repeat steps
1
and
2
.
7 If the washer will still not work you will be required to call a Fisher & Paykel Authorised
Repairer to arrange service, refer to the ‘Customer care’ section. Record the fault code
number displayed and the serial number of your washer (located above the drum
opening when the door is open) before calling. The fault code will indicate to the
repairer what the problem could potentially be.
If a fault code is being displayed, you can still turn your washer off by pressing
.
To Next Page
Loading...
