Fisher & Paykel WH8560J1 - Operating Modes and Cycle Progress; Special Operation Features

479646
14
Options
Press this button to select the ECO and Wrinkle free functions.
Wrinkle free (P models only) is for loads that are not going to be removed after the completion of the wash
cycle and will tumble the clothes every 15 minutes for up to 12 hours.
The ECO function saves energy and water. This function reduces the wash temperature slightly and
increase the wash time by approximately 10 minutes.
Add a Garment (P models only)
Used to add or remove items during the wash stage of the cycle under certain conditions. It will only operate
during the wash cycle and if the wash temperature is less than 60
O
C.
Start/ Pause
Press this button to start the selected wash cycle. Operation can be paused at any time by pressing the
button. The display will begin to blink and the operation will stop. To continue, press the button again.
5.2 Power off Memory Function
The machines have a built in memory function. If the power goes off, the washing machine will remember
the current settings and place in the wash cycle. It will automatically return to the same place in the cycle
and continue when the power is restored.
5.3 Operating Modes
5.3.1 Drain Pump
The filter of the drain pump requires cleaning approximately once a month. The pump will automatically
activate if the machine over fills.
5.3.2 Filling With Water
The machine fills with a combination of cold & hot water for the main wash e.g. Cotton 60, with the rinse
being of cold water.
5.3.3 Washing and Heating
When the wash requires a wash temperature that is greater than the mixed inlet temperature, the machine
heats the water with an on board element. The temperature is subject to the program selection and is
monitored by the temperature sensor.
5.3.4 Add a Garment (P models only)
This function is only available during a wash cycle with a selected wash temperature below 60 degrees.
When the ADD A GARMENT button is activated, the machine will pause and the start/pause LED will flash.
The pump will turn on and pump out some of the wash water if the level is above the door seal. To continue
the wash, press the start/pause button.
5.3.5 End of Cycle
At the end of cycle the machine stops automatically with the screen displaying the word END.
5.4 Wash Progress Display
The display has LED indicators that illuminate as the machine progresses through each of the steps of the
cycle: Wash, Rinse and Spin.