Fisher & Paykel WH8560J1 - Replacing Drum Vane; Removal of the Door Lock

479646
22
13. Remove the 6 stainless screws holding the
drum to the shaft and remove the drum.
Reassemble in the reverse order.
7.2.9 Replacing Drum Vane
1. To remove the drum, follow the procedure for
removing the top panel (refer to Section 7.2.1).
2. Remove the kick panel (refer to Section 7.2.3).
3. Remove the cabinet bellows clamp (refer to
Section 7.2.4).
4. Remove the control panel (refer to Section
7.2.5).
5. Remove the front panel (refer to Section 7.2.7).
6. Remove the drum assembly (refer to Section
7.2.8).
7. Remove the screws holding the vane and unclip
it.
Reassemble in the reverse order.
7.2.10 Removal of the Door Lock
1. Follow procedure for removal of table top (refer
to Section 7.2.1).
2. Release the bellows clamp to allow access to
the door lock assembly, (refer to Section 7.2.4).
3. Undo the 2 screws holding the door lock.
4. Remove the lock assembly from inside the
machine and disconnect the harness.
Reassemble in the reverse order