Fisher & Paykel WH8560J1 - Health and Safety Precautions; General Safety Precautions

479646
5
1 HEALTH & SAFETY
When servicing the washer, health & safety issues must be considered at all times. Specific safety issues are
listed below with the appropriate icon.
Electrical Safety
Ensure the mains power has been disconnected before servicing the washer.
If the mains supply is required to be on to service the washer, make sure it is
turned off when removing any electrical component or connection to avoid electric
shock.
Electrostatic Discharge
An anti-static strap is to be used as electrical static discharge (ESD) protection
when servicing electronic components.
Good Working practices
Ensure the work area is in a tidy and orderly condition at all times so as not to
cause a hazard while service work is being completed. Always clean and tidy the
washer and work area after service is completed.
Isolate Water Supply
Turn off the water connection tap before servicing
Water Leak Check
Check for water leaks as part of the testing after the service has been completed.
Insulation test
Megger test to check insulation
Warning: short together the phase and neutral pins on the plug so not to damage
any electronic circuitry.
Sharp Metal Edges
When working around cut sheet metal edges, use appropriate gloves or protection
to eliminate the change of receiving a laceration.