Solving Operating Problems
Pressing POWER Does Not Turn On Washer
• Is the power switched on at the wall?
• Unplug from wall. Wait 60 seconds, plug back in, turn on and try again.
• Could household power supply be at fault? Try plugging in another appliance in the same power socket.
• Keylock mode may be activated. Try holding down the POWER button for 3 seconds (refer to page 20).
Pressing START/PAUSE Does Not Start the Fill
• Are both hot and cold faucets turned on?
• Are the inlet hose filters blocked? Check both ends of the hoses.
• Is DELAY START set?
Filling Continuously
• Ensure drain hose is located in the standpipe or tub / sink.
• Ensure standpipe or tub / sink is at least 33 1⁄2” (850 mm) high but no more than 95” (2413 mm) high.
• Check that the washer is not siphoning (refer to page 9).
Not Spinning Properly
https://producthelp.fisherpaykel.com/us/Wash/Top_Loaders/AquaSmart_Eco/WL4027G1/User_Guide_WL4027G1/22_solving…
Updated: Fri, 12 Nov 2021 17:06:25 GMT
Powered by
1
To Next Page
Need help?
General
