2 3
www.fisher-price.com
Assembled Parts
Curved Track – 5
Straight Track – 4
Curved Elevation Track
Ramp Track with
Guardrails – 2
Shack
Upper Mountain Lower Mountain
Short Track – 2Small Trestle – 2
Large Trestle – 1
Easy Rail Station Station Track Piece
1,5V x 6
“AAA” (LR03)
Battery Installation
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
IMPORTANT! Under normal use conditions, the batteries in the vehicle will require
replacement more often than the batteries in the remote controller.
Remote Controller
• Locate the battery compartment on
the bottom of the remote controller.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver. Remove the battery
compartment door and insert three
“AAA” (LR03) alkaline batteries.
• Replace the battery compartment
door and tighten the screw with
a Phillips screwdriver. Do not
over-tighten.
• If this product begins to operate
erratically, you may need to reset
the electronics. Remove the batteries
and replace them in the toy.
Engine
• Locate the battery compartment on
the back of the engine.
• Loosen the screws in the battery
compartment door with a Phillips
screwdriver. Lower the battery
compartment door and insert three
“AAA” (LR03) alkaline batteries.
• Close the battery compartment door
and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
• If this product begins to operate
erratically, you may need to reset the
electronics. Remove the batteries and
replace them in the toy.
Please keep this instruction sheet for future reference, as it contains important information.
Requires six “AAA” (LR03) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included)
To Next Page
Need help?
General
