Page 102 Operator‘s Manual FERITSCOPE
®
FMP30
Measuring
7.6 Erroneous Readings
7.6.1 Deleting Erroneous Readings
If an erroneous reading is recognized directly after measurement acquisi-
tion, the reading can be deleted by pressing DEL.
The deleted reading will then not be included in the generation of the block
and final results.
Repeated pressing of DEL will delete all readings of the open block in suc-
cession.
7.6.2 Deleting All Readings of a Block That Has Not Been Closed
Pressing DEL during an evaluation of an open block will delete all readings
that are stored in the open block that has not been closed
( 8.1 ‘Evaluation of the Current Block “Block Result”’, beginning on
Page 118).
7.6.3 Deleting All Readings of an Application
All readings stored in the open application can be deleted completely
during the evaluation of the open Application. This is accomplished by
pressing FINAL-RES and then twice the DEL ( 8.2 ‘Evaluation of the
Open Application “Final Result”’, beginning on Page 124).
To Next Page
Loading...