Operator‘s Manual FERITSCOPE
®
FMP30 Page 105
Measuring
7.7 Measurements in the Free-Running Display Mode
When making measurements in the “free-running” display mode, the -fer-
rite content distribution across the surface can be determined simply by
moving the probe along the surface. With the “free-running” display mode,
the readings are displayed continuously, and
the readings are not accepted and stored automatically,
the date are output continuously via the interface port only if [Free-run-
ning transmit on] has been selected from the Service functions.
As long as the “free-running” mode is on, measurement acquisition can
be triggered using ENTER.
ENTER
Use ENTER to end the block result display.
The last block will be closed automatically
and a new block will open. If additional
measurements are to be made in the last not
yet closed block, do not press ENTER; in-
stead, select the still open block and press
the arrow
.
The instrument is again ready to make mea-
surements.
Measurements that are outside the measurement range, e.g., when the
probe is lifted off the surface, are also output to the interface port.
Key sequ. /
Action
Detail of the display Explanation
To Next Page
Loading...