Page 114 Operator‘s Manual FERITSCOPE
®
FMP30
Measuring
Automatic Block changing
Automatic Block changing must be selected for the next reading to be stored
in the next block automatically. Free block selection is not available with
automatic block changing!
After the audible signal for the measurement acquisition, a long audible sig-
nal will sound to indicate block changing ( 7.3.4 ‘Audible Signals After
the Measurement Acquisition’, beginning on Page 90).
Manual Block changing
Block changing must be done manually in order to allow for a free selection
of the block where the next reading is to be stored. The desired block must
be selected before making the measurement.
If manual block changing is selected, it is possible to store one reading in
block 7 and the next in block 3, for example.
Key sequ. /
Action
Detail of the display Explanation
BLOCK-RES Use BLOCK-RES to start the block selec-
tion.
will appear on the display.
[Block:]: Number or name of the current
block
[n=]: Number of readings stored in the cur-
rent block.
DATE and TIME display
[fe.]: Displays the mean value of the current
block.
[s]: Standard deviation of the measure-
ments made
[COV]: Coefficient of variation
To Next Page
Loading...