Page 168 Operator‘s Manual FERITSCOPE
®
FMP30
Instrument Settings - Service Function Menu
10.6.2 Analog Display
When making measurements in the “free-running” display mode, the ana-
log display facilitates a quick recognition of tendencies in the -ferrite con-
tent changes. If analog display is enabled and measurements are made in
the “free-running” display mode, the analog display with the set limits will
appear in place of the information lines. The reading will appear between
the limits as an analog bar.
Key sequ. /
Action
Detail of the display Explanation
Select Device Mode by pressing the arrow
keys
or and confirm the selection with
ENTER.
ENTER Select Analog display by pressing the ar-
row keys
or and confirm the selection
with ENTER.
ENTER
Select the desired display mode by pressing
the arrow keys
or and confirm the se-
lection with ENTER.
[off]: Analog display disabled
[on]: Analog display enabled, i.e., when
making measurements in the “free-running”
display mode, an analog bar will appear in
the information lines to indicated the mea-
sured value ( 7.7.3 ‘Analog Display’, be-
ginning on Page 108).
Use DEL at any time to cancel the setting
procedure.
To Next Page
Loading...