Page 210 Operator‘s Manual FERITSCOPE
®
FMP30
Glossary
Kolmogoroff Smirnoff Test
Test, which is performed when evaluating the current application with
the FERITSCOPE
®
FMP30 to determine whether the evaluated measure-
ments can be classified as having normal distribution (if up to 40 mea-
surements are to be evaluated).
Kurtosis Curvature
Line feed (LF)
LF line feed. Advances the printer paper by one line. Is usually used to-
gether with the CR (carriage return) character to start the next line at the
beginning.
LSL
Lower specification limit. Specification limits (LSL and USL)
Local -ferrite content
The local -ferrite content is the arithmetic mean value of the single mea-
surements performed on the reference area.
Master calibration
Adjustment of the instrument using calibration standards. During a mas-
ter calibration, the master calibration curve is determined. The master
calibration includes calibration and adjustment.
Master characteristic (Probe characteristic)
Characteristic of the measurement system, ( Calibration curve
(characteristics)). The master calibration curve is determined during
master calibration on the Base and calibration standards and is the ba-
sis for determination of the measurement values, since it represents the
relationship between the -ferrite content and the probe signal. The co-
efficients of the master calibration curve are stored in the EEPROM of
the probe plug.
Maximum
Highest reading of a measurement series.
Maximum value
Maximum value measured in a test series.
Mean value Fe.
Measurement
Numeric reading of an instrument, expressed in the unit of measure-
To Next Page
Loading...