Fisher FERITSCOPE FMP30 - System Setup, Maintenance and Cleaning

Operator‘s Manual FERITSCOPE
®
FMP30 Page 21
System Setup, Maintenance and Cleaning
3 System Setup, Maintenance and Cleaning
System setup consists of the following steps:
 Providing the power supply for the instrument
( 3.1 ‘Voltage supply’, beginning on Page 22)
 Connecting a measurement probe to the instrument
( 3.2 ‘Connecting Probes’, beginning on Page 25)
 Connecting a printer (where applicable) to the instrument
( 9.6 ‘Connecting a Printer’, beginning on Page 141)
 Connecting a computer (if desired) to the instrument
( 9 ‘Data Transfer’, beginning on Page 131)
 Selecting the language for the instrument if your language has not
been set when the instrument was shipped
( 10.2.1 ‘Language’, beginning on Page 144)
Connect or disconnect plug-type connectors only when the instru-
ment is switched off in order to avoid electrical discharge. Connect-
ing the AC adapter or inserting a battery should be done carried
out with the unit turned off as well! Even a small discharge can
delete the instrument memory.
Do not tilt the plug when inserting or unplugging them; doing so
could damage the contact pins of the plugs.
The information in the chapter “1 Important Information” must be
observed!