Operator‘s Manual FERITSCOPE
®
FMP30 Page 39
Applications
ENTER if [always ask] is selected from the service
function Measurement/Unit
( 10.7.5 ‘Unit’, beginning on
Page 179), select the unit of measurement
for making the measurements in the Appli-
cation at this point:
Use the arrow keys to select the unit.
[Fe%]: The
-ferrite content will be mea-
sured in ferrite percent.
[FN]: The
-ferrite content will be measured
in ferrite numbers.
[OK: ENTER]: Use ENTER to confirm the
selection.
ENTER Use ENTER to start setting up the Applica-
tion.
ZERO appears on the display.
[Base material (Fe)]: The measurements
for the normalization should be made on
base.
ENTER: Cancels the normalization.
Performing the normalization: beginning
on
Page 61.
Key sequ. /
Action
Detail of the display Explanation
To Next Page
Loading...