Lit. No. 85309, Rev. 03 7 July 15, 2020
INSTALLATION INSTRUCTIONS
3. Install the rubber bumpers using 5/16" x 5" cap
screws, 5/16" at washers, and 5/16" locknuts, as
shown on facing page. Tighten the fasteners until
the bumpers begin to dimple.
4. Move the blade back to upright position.
5. Reinstall the trip springs.
6. Adjust the trip springs by tightening the top nuts
until the coils of the springs begin to separate
(a piece of paper, such as this instruction sheet,
should pass between the second and third coils).
7. Remove the protective packaging from the angle
rams. Align the holes in the rod end of the angle
ram with the corresponding holes on the back of
the quadrant.
8. Install a 1/2" x 3‑11/16" clevis pin from the top
down to attach each rod. Secure the clevis pins
with cotter pins from the parts bag.
9. Install the blade guides.
10. With the A‑frame parallel to the ground, secure
the stand by pulling the stand lock pin out and
letting the stand drop to the ground. Release the
stand lock pin and verify that the stand is secure
by pulling up on the stand.
11. Finish securing the cutting edge with two carriage
bolts and locknuts (included in the parts bag).
12. Install the receivers into the truck mount pockets
using the pins provided in the receivers.
Blade
Guide
7/16"
Lock
Washer
7/16"
Nuts
and
Pin
Stand
To Next Page
Loading...