Lit. No. 69829, Rev. 01 7 December 15, 2016
69400, 69450, 69450-1, 69450-2
HEADLAMPS
Headlamps, hardware and instructions are found in
the headlamp box.
1. Attach the headlamps to the hole and slot in the
headgear light bracket by following the instructions
included with the headlamps.
2. Secure the snowplow harnesses and cables to the
headgear as shown.
3. Insert seven cable tie anchors into the 1/4" holes
on the rear of light bar from the inside, with the
locking tabs horizontal.
4. Install a split rubber grommet on each headlamp
wire 3" from the headlamp and insert the grommet
and wire into the slot on the rear of the light bar.
5. Route the wires underneath the light bar, behind
the vertical supports, and down along the inside of
the driver-side vertical support, securing the wires
to the anchors with cable ties.
Cable Boot
Snowplow
Lighting
Harness
Snowplow
Battery
Cable
Cable Ties
WARNING
Your vehicle must be equipped with snowplow
headlamps and directional lights.
To Next Page
Loading...
