USING SPACEXPANDER JACKS ON FISHER INSTRUMENTS
There are no problems when making connections to a FISHER stereo instrument with
Spacexpander
jacks Just pullout the pair of horse-shoe shaped jumpers and insert the plugs of the
interconnecting cables. DO NOT discard the jumpers (They can be handy when troubleshooting the
home music system). The jumpers
must
be reinserted when the
Spacexpander
is disconnected.
These jumpers complete the internal signal paths -without them the home music system will not
play; no sounds, except for a slight hiss or hum will be heard from the speakers.
CONNECTIONS
Make the following connections between the
Spacexpander
Electronic Unit and the FISHER
instrument
Spacexpander
jacks using 4 of the 6 audio interconnecting cables.
• Left TO REVERB IN jack connected to
(left) A INPUT of
Spacexpander.
• Left TO REVERB OUT jack connected to
(left) A OUTPUT of
Spacexpander
.
• Right TO REVERB IN jack connected to
(right) B INPUT of
Spacexpander.
• Right TO REVERB OUT jack connected to
(right) B OUTPUT of
Spacexpander.
Make the following connections between
the
Spacexpander
Electronics Chassis and
the Reverberation Chassis using 2 of the 6
audio interconnecting cables.
• INPUT jack of Reverberation Chassis to
jack marked TO INPUT OF REVERB UNIT
(chassis)
• OUTPUT jack of Reverberation Chassis to
jack marked to OUTPUT OF REVERB UNIT
• Set
Spacexpander
MODE SELECTOR switch
to NORMAL.
Connecting to FISHER instruments with Spacexpander jacks is the easiest installation because
these instruments were designed to go together.
To Next Page
Loading...