THE CENTER CHANNEL AND THE SPACEXPANDER
Spacexpander
center-channel reverberation can be used two ways - either full reverberation
without any of the pure, original signal (MODE SELECTOR switch set to the REVERB ONLY position)
or with the pure signal and an adjustable amount of reverberated signal when the MODE SELECTOR
switch is set to the CENTER position. Try both positions before you decide where the MODE SELECTOR
switch will be set - you may find that your original choice does not give you the effect you
expected. Too much reverberation will give an unreal effect of a large, live, auditorium and
excessive echoes will make all tones and notes so fuzzy or blurred that they will run together and
be lost.
In the CENTER position the Control Unit knob will change the
amount
of reverberation heard from
the center-channel speakers - it wilt not change the volume, just the reverberation. When the
MODE SELECTOR switch is set to REVERB ONLY the Control Unit knob will act like a volume control
for the center channel. The only sound you hear from the center channel will be reverberated
sound. Since the Control Unit knob controls only the reverberated signal and there is no other
signal in this mode, the reverberated sound from the center-channel speaker increases and
decreases as the knob is rotated from the MINimum to MAXimum positions just like a volume
control.
To Next Page
Loading...