Lit. No. 44224, Rev. 14 58 August 15, 2011
OPERATING YOUR SNOWPLOW
Manual Unlock
If the SECURITY GUARD system is activated
and you are using a control with a different 4-digit
code than the established security code, you will
be required to manually enter the 4-digit security
code before operating a locked snowplow.
1. Turn the vehicle ignition to the "ON" or
"ACCESSORY" position.
2. Move the ON/OFF switch to the "ON" position
or push the ON/OFF button to switch the
control ON.
3. The power indicator light will fl ash rapidly,
indicating that the snowplow is locked.
4. Enter the 4-digit security code.
Once you have entered your 4-digit
security code, the FLOAT light will stop
fl ashing and The power indicator light will
turn OFF. This indicates that your 4-digit
security code is entered and stored in the
SECURITY GUARD™ system.
4. Once a 4-digit security code is established
and the plow/vehicle electrical connection are
lost/disconnected, the SECURITY GUARD
system will recognize any control that has
been programmed with the same 4-digit
security code. Any control not programmed
with the correct 4-digit security code will
require the user to enter the established
security code before activating the snowplow
(see the Manual Unlock procedure).
NOTE: If the control is turned ON prior to
completing the programming procedure, your
4-digit security code will be cancelled.
To Next Page
Loading...