OUBLE HOOTI G
GU
DE
If you have followed the
instructions
in the CONNECTING and CONTROLS sections, and have
difficulty
operating
your
double
cassette deck, locate the SYMPTOM in the left column below.
Check
the
corresponding
POSSIBLE CAUSE and
CORRECTIVE ACTION
columns
to locate
and
remedy the problem.
SYMPTOM
POSSIBLE CAUSE
No tape transport.
The double
cassette
deck
is not plugged in
properly.
Cassette
is not inserted
properly
.
PAUSE button Is
depressed
.
No
playback
.
The double
cassette
deck
is not
connected
properly.
The
amplifier
is not
set
properly
.
Recording
is
not
possible.
Erase guard tabs on the
cassette
have been
removed.
The
double
cassette
~ck
is not
connected
properly.
INPUT LEVEL
controls
are
at
minimum
position
when
uSiFlg
wnh DECK ?
Tape heads are dirty.
SYNCHRO START
switch
is not
set
properly.
Playback
distorted.
Input
level too high.
DECK-2
TAPE SELECTOR
switches
In
the
wrong position when using with DECK
2.
Using the wrong type of tape for
this
double
cassette
deck.
Poor high
frequency
DECK-2
TAPE SELECTOR
switches
in the
reproduc
tion.
wrong
position when using with DECK
2.
Wrong type
of
tape.
Tape heads are dirty.
PreviOUS
recorded
material
Tape heads are
dirty
.
is not
or
only
partly erased.
Recordings
have
Tape heads are dirty.
background
noise.
CORRECTIVE ACTION
Check
if the power
cord
is plugged in properly.
Insert
the
cassette
properly.
Depress the PAUSE button again.
Check
cables
between the double
cassette
deck
and
amplifier.
Depress the TAPE MONITOR
switch
on amplifier.
Use another cassette,
or
cover the opening with
adhesive tape.
Check
connections
between the
double
cassette
deck
and amplifier.
Slide INPUT LEVEL
controls
to the
correct
level.
Clean the heads.
Set SYNCHRO ST ART
switch
to the
correct
position
.
Re-record
at
proper
level.
Set to the
correct
type
of
tape.
Change over to the proper type of tape.
Set to the
correct
type
of
tape.
Change to the
proper
type of tape.
Clean the heads.
Clean the heads.
Clean the heads.
11
To Next Page
Loading...