6. BLUE TOOTH PAIR THE APP WITH SONAR
Important reminders:
- It takes about 2 hours to fully charge your
FishHunter sonar.
- Your fishfinder body does not operate in air; it
only works when it is placed on the water
surface. Please deploy it in water before you
begin the following Bluetooth connection
process.
- Your fishfinder connects to your mobile device
using Bluetooth connection. The fishfinder
broadcasts a signal that your phone will pick up
and connect with.
Step 1:
Ensure your fishfinder is fully charged by
following the charging instructions above.
Step 2: Place your sonar into water. You will see
that the sonar’s red lights are blinking fast and
eventually stay lit to indicate that the sonar is
“waking up.” If the red light is not on, the sonar
is OFF.
To Next Page
Loading...
