EasyManuals Logo

Fishman B II User Manual

Fishman B II
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Volume
For the cleanest signal, set this as high as possible without distorting your amp or
mixer
Optional Belt Clip
Attaches to the back of the Pro EQ II with two screws.
PRO-EQ II TONE CONTROLS
Bass
A Boost here will add depth and weight to the sound of an instrument with light bass
response. Lower the bass a few dB to tighten up the big boomy tone of a
dreadnought or jumbo guitar.
Middle
More than any other control, the middle slider can affect the character of your
instrument's tone. Typically, a slight mid cut just below the center detent will help
bring out roundness in the bass and will unmask the treble. A deep midrange cut
produces a "scooped out" tone that works well at high volume levels and can help to
reduce feedback. Boost the mids for an "in your face" nasal quality, similar to electric
guitar tone.
Treble
A Boost here will help to "cut through the mix". Conversely, cutting the Treble will
mellow and subdue your amplified tone.
Brilliance
This slider can add shimmer and sparkle to your sound. It zeros in on "extra crispy"
high frequency tones, the realm of harmonics and acoustic string sound. Lowering
the Brilliance slider can help to reduce finger noise and fret buzz.
Optional Belt Clip
Attaches to the back of the GII or BII with two screws.
MODEL GII SPECIFICATIONS
Measured with all tone controls at center detent and volume at max.
Nominal Input Level: -20 dBV
Input Overload (20 Hz to 20 kHz): +8 dBV
Input Impedance: 10 MOhm
Output Impedance: Less than 3.5 kOhm
Output Level: -20 dBV with input gain
control at minimum position
-8 dBV with input gain
control at maximum position
THD: .01% at 1 kHz, -10dBV input, -4 dBV output
Signal to Noise Ratio: 91 dB (A weighted, -10 dBV input,
-4 dBV output)
Bass Control Range: ± 11dB at 60 Hz
± 3 dB at 350 Hz
Treble Control Range: ± 11dB at 10 kHz
± 3 dB at 2.4 kHz
Current Drain: Less than .4 mA
Power Supply: 9V alkaline battery (estimated 1400 hours
continuous use) Regulated 9V AC Adapter
Tip = negative 9 V
All specifications subject to change without notice.
6
6
Outboard Acoustic Preamps
Outboard Acoustic Preamps
11
11
User Guide
User Guide

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fishman B II and is the answer not in the manual?

Fishman B II Specifications

General IconGeneral
BrandFishman
ModelB II
CategoryAmplifier
LanguageEnglish

Related product manuals