PRO EQII FEATURES
Power
You can power your Pro EQII two ways:
1 - 9 Volt Battery
Remove the battery compartment lid by sliding it up towards the top of the unit.
Place a fresh 9 Volt alkaline battery in the compartment and replace the lid.
NOTE: Make sure the battery is installed with the correct polarity.
You can expect 220 hours of continuous use. To conserve the battery, unplug the
input when you are not using the preamp. When you start to hear distortion from
the preamp, it is time to change the battery.
2 - Nine-Volt AC Adapter Input
Use only a Fishman 910-R or Boss PSA series regulated AC adapter. If a 9 Volt
battery is in the preamp, no battery drain will occur when you use the AC adapter.
Output
Plug a standard instrument cable from the output to a stage amp, DI or an
unbalanced microphone input on a Mixer.
Input
The input accepts all piezo and magnetic pickups (passive or active).
When you plug in here, the 9 Volt battery switches on. To conserve battery life,
remember to unplug the input jack when you are not using the preamp. It is a good
idea to turn down your amp or mixer's input before you plug into the input. Doing so
will protect your speakers (and your ears) from loud pops.
Input Gain
You'll find this control located on the back of the preamp, to the left of the sub bass
control. Like a trim control on a mixer, the input gain accommodates a variety of
signal levels. Use a slot head jeweler's screwdriver to raise or lower the input level.
Pro EQ II
Pro EQ II
The Pro EQ II is an upgraded and updated version of our classic preamp/equalizer.
It is well suited for all acoustic instrument pickups. Enclosed in a tough injection
molded case, the Pro EQ II features advanced new electronics which are quieter,
cleaner and offer longer battery life than our original Pro EQ preamp.
8
8
Outboard Acoustic Preamps
Outboard Acoustic Preamps
9
9
User Guide
User Guide
To Next Page
Loading...
Need help?
General