Step 16: Install the leg and connect with the harness
Connect the leg support U-shaped tube into the liner’s lower stretchable flap. Attach the legs towards the
outer end of the tube. Both tubes should be facing outwards (see figure below).
Attach the tube connections to the U-shaped tube firmly. Each of the standing legs should be assembled
in the same fashion. Attach the tube connections to the U-shaped tube firmly. Each of the standing legs
should be assembled in the same fashion.
THE IPOOL INSTRUCTION MANUAL
Pool Set-Up
Please carefully read this instruction manual
before installing and using the iPool
18
To Next Page
Loading...
