Step 7: Insert the framework long straight tube into the liner,
making sure the holes for the pipe legs line up with the openings
in the liner
Make sure the frame is not upside down during insertion. The push pins are for holding the tubing
together during installation, but the holes of the straight tubes must be facing outward towards
where you will insert the u shaped leg support (#5) tubes.
Step 8: Connect the long elbow tube with the framework short
elbow tube on the width side of the pool into the liner
When you perform this step, you should have someone assist you, because the liner and frame
pieces may be heavy when inserting them.
THE IPOOL INSTRUCTION MANUAL
Pool Set-Up
Please carefuy read is instruction manual
before instaing and using e iPl
14
Figure 1: Upside tubing example
To Next Page
Loading...
