Step 22: Filling your iPool with water.
After installation is complete, and before filling with water, make sure that all connections are correctly fastened,
and that there are no cracks or holes. After passing inspection, add water until the water level reaches engraved
line on the liner.
Please note that water naturally accumulates on the bottom during filling. If you see small puddles near the floor
of the pool, there is a good chance that is not a leak or puncture because the liner is very strong. In the unlikely
event of an actual puncture, the water level will drop approximately one inch per day. For more information, see
When water puddles appear outside the iPool during filling in the Troubleshooting section (page 36).
Figure 2: Example of a non-leak due to filling
Figure 1: Completed installation
THE IPOOL INSTRUCTION MANUAL
Filling the Pool
Please carefuy read is instruction manual
before instaing and using e iPl
28
To Next Page
Loading...
