EasyManua.ls Logo

FitMax THE IPOOL - Page 37

FitMax THE IPOOL
37 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When water puddles appear outside the iPool during filling
Please note that water naturally accumulates outside the pool during filling. If you see small puddles near the floor of
the iPool, there is a good chance that it is not a leak or puncture, because the liner is very strong. Due to the eect of
gravity and the shape of the liner, all excess water accumulates to the floor and can get pushed out from the bottom.
If you are concerned about a possible leak or damage to the liner, we recommend that you do NOT drain your iPool!
Simply stop filling the pool, place a piece of duct tape at the top water level mark, and then wait a day to see if the
water level drops. The water level will start dropping about an inch a day if there is actual damage to the pool liner,
such as an actual puncture.
Note: Do not let your partially filled iPool sit for a day without first marking the top water level with duct tape. Its very
dicult to determine if the water level has dropped, simply by a casual “eyeball” inspection.
If there is no drop in the water level, you can use bathroom towels to mop up the excess water, and then resume
filling your iPool.
Figure 1: Example of a non-leak due to filling
THE IPOOL INSTRUCTION MANUAL
Troubleshooting
Please carefuy read is instruction manual
before instaing and using e iPl
36

Related product manuals